how to make a site
Mobirise

Do you want to use your own Arduino Uno Board with FlowLogic 6?

You will need a CD-Key to upload the companion firmware into your board from FlowLogic 6

FlowLogic 6 Companion Firmware

This firmware is a piece of software that you need to upload into your Arduino UNO board in order for FlowLogic 6 to communicate with the board and enables the functionalities of FlowLogic 6's Arduino Control command blocks to carry out physical computing activities using the boards's I/Os as listed below.

To upload the Firmware to your Arduino Uno Board, you will need to purchase a CD-key. The first time you perform the upload process, will activate FlowLogic 6 communication with the Firmware loaded Arduino board for life. There is no limit to the number of Arduino Uno Board that you can upload the firmware from FlowLogic 6, as long as you use a new CD-key for each board.

Board Supported : Arduino Uno R3 ATmega328P ATMEGA16U2 
with Arduino USB Driver or CH340 USB Driver

The firmware automatically configures the I/O pins of your Arduino UNO board as following for extenal devices connection :

Digital Output - 5 pins - Pin 6,7,8,9,10
Digital Input - 4 pins - Pin 2,3,4,5
Analog Output - 4 pins - Pin A0,A1,A2,A3
PWM - 3 pins - Pin 6,9,10
Servo Motor control - Pin 12,13
Proximity Sensor (Sonar) - Pin 2,3
I2C 16x2 LCD panel - SDA, SCL (Base Addr: 0x3F)
DHT 11 Sensor - Pin 5
Pezio Buzzer (Tone) - Pin 9
Shift register - Pin 8,9,10
Robotic application (servo Control) - Pin 9,10,11,12,13

Watch the video below to learn on how to upload the firmware into your board
Please install the Arduino USB driver first, Go to Tutorials to learn more

Purchase your CD-KEY Here

to upload FlowLogic 6 Companion Firmware into your own Arduino Uno board.
The CD key(s) will be sent to your email

Only $5 per CD-Key

Address

B-23A-5, Pinnacle Petaling Jaya  Jalan Utara C, 46200 PJ, Selangor, Malaysia.

Enquiry

Email:
sales@myflowlab.com
               

Technical Support

Email:
support@myflowlab.com
+6-012-617-0206